Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DESCRIPTION OF OPERATION
PHASE SHIFT
13
This controller allows to adjust the phase between 0° and 180°. This allows that the running time of the
subwoofer signal can be matched to the full-range loudspeakers. Set the controller so that all signals
arrive in the acoustic center at the same time.
PURE
14
The PURE button activates the bypass mode of the amplifier. This means the audio signal will be only
amplified and the filter section bypassed. The amplifies frequency range is 6 to 1250 Hz. The control-
lers SUB SONIC, LOW PASS, BASS BOOST and PHASE SHIFT are in this mode without function.
Only the bass level remote controller at RLC works in this mode.
AUTO TURN-ON
15
If your head unit does not have a turn-on signal (REM), you can use the automatic turn-on function of
the amplifier. This works in two ways, which can be set at the AUTO TURN-ON switch:
DC: This method only works if you use the amplifier's HIGH LEVEL INPUT. The amplifier then detects
a voltage rise to 6 volts when the head unit is turned on by a so-called "DC offset" and then turns on
the amplifier.
SIG.: Select this method when using the INPUT RCA jacks. The amplifier then detects a voltage in-
crease in the incoming audio signal when switching on the head unit via the attached RCA cable and
then switches on the amplifier.
Note: As soon as the head unit is switched off again, the amplifier switches itself off.
The terminal for the amplifier turn-on (Refer to page 6, section 2) can now be used to supply additional
amplifiers with a turn-on signal. Simply connect the REM terminals of the two amplifiers and make sure
that the other amplifier is in "normal" turn-on mode, which means that the AUTO TURN ON function
is disabled.
16
RLC
The RLC port is for connecting the cable of the included bass level remote controller. With this, the
bass level can be e.g. be adjusted from the driver's seat. Only use the supplied bass remote controller
and the associated cable.
POWER/PROTECT
17
If the LED lights up in green, the amplifier is ready for operation. If the LED lights up in red, there is a
malfunction. Refer in this case to chapter TROUBLE SHOOTING on page 14.
ENGLISH
9
Werbung
