Routing Cables - Dell PowerEdge 1955 Installationsanleitung

CAUTION:
It is recommended that more than one person assist in lifting the system.
NOTICE:
It is recommended that you use a lift table to aid in installing the system in the rack, particularly
if the rail assemblies are more than waist-high.
1 Lift the system into position to install it in the rack.
It is recommended that more than one person assist in lifting the system.
2 Guide the system into the rack and lower the system onto the rail assemblies (see Figure 1-7).
3 Tighten the thumbscrews on the rack front panel.
Figure 1-7. Installing the System in the Rack
thumbscrews (4)
rail assemblies (2)

Routing Cables

1 Attach the I/O cable connectors and power cables to their respective connectors on the
system back panel. For details on cable connections, see your system's Getting Started Guide,
Installation and Troubleshooting Guide, and User's Guide.
NOTE:
Use the strain-relief loops (if available) on the back of the power supplies to provide strain
relief for the power cables.
Rack Installation Guide
13