Installing The Cable-Management Arm; Routing Cables; Installing The System In The Rack (Rapidrails Or Versarails) - Dell PowerEdge 2800 Installationsanleitung

Installing the System in the Rack
CAUTION:
NOTE:
slide assemblies.
1
Pull the slides out to their fully extended position.
CAUTION:
assemblies by yourself.
2
Lift the system into position (see Figure 1-18).
3
Place one hand on the front-bottom of the system and the other hand on the back-bottom
of the system.
4
Tilt the back of the system down while aligning the back shoulder screws on the sides of
the system with the back slots on the slide assemblies.
5
Engage the back shoulder screws into their slots.
6
Lower the front of the system, and engage the front and middle shoulder screws in their slots.
The middle slot is just behind the system release latch (see Figure 1-18).
When all shoulder screws are properly seated, the system locking mechanism at the front
of each slide assembly clicks and locks the system into the slide assembly.
7
Press up on the slide release latch at the side of each slide to slide the system completely
into the rack (see Figure 1-18).
8
Push in and turn the captive thumbscrews on each side of the front chassis panel to secure
the system to the rack.
NOTE:
locking mechanism, and then pull the system forward.

Installing the Cable-Management Arm

See "Installing the Cable-Management Arm" in "Four-Post Rack Installation" found earlier in this
document.

Routing Cables

See "Routing Cables" in "Four-Post Rack Installation" found earlier in this document.
You have completed the installation of the rack kit in a two-post rack.
1-30
Rack Installation Guide
Due to the size and weight of the system, never attempt to install the system by yourself.
The procedure for installing a system into a rack is identical for flush-mount and center-mount
Because of the size and weight of the system, never attempt to install the system in the slide
To remove the system from the slide assemblies, press down on the thumbpads of the system