Dell PowerEdge 1750 Handbuch Seite 8

F i g u r e 1 - 3 .
battery standoffs (2)
Install the ERA/O card in the ERA/O card connector (EMBEDDED_REMOTE_
9
ASSISTANT) on the system board. See Figure 1-4.
a
b
1-4
I n s t a l l i n g o r Re p l a c i n g a n E RA / O C a r d
R e m o v i n g t h e R O M B B a c k u p B a t t e r y
ROMB backup
battery
ERA/O card
connector
Align the connector on the bottom of the ERA/O card with the ERA/O connector
on the system board; align the holes along the edges of the card with the center
posts of the four retention clips on the system board.
Press the card down into the connector and onto the retention clip posts until the
clips snap into place around the card and the card is fully seated into the
connector.
ROMB card
RAID BATTERY connector