F i g u r e 1 - 1 .
optional security screw
Remove the SCSI backplane board:
6
a
b
c
d
1-2
I n s t a l l i n g o r Re p l a c i n g a n E RA / O C a r d
O p e n i n g t h e S y s t e m C o v e r s
left cover
latch
Pull each hard-drive carrier partially out of its slot, approximately 2.5 cm (1 inch).
Disconnect the diskette-drive interface cable from the FLOPPY connector on the
backplane board. See Figure 1-2.
Disconnect the CD drive interface cable from the CD_ROM connector on the
backplane board. See Figure 1-2.
Press the release latch in toward the backplane board and use the handle to pull
the board out of its connector and up out of the chassis. See Figure 1-2.
right cover