Dell PowerEdge 1750 Handbuch Seite 10

Reconnect the system and peripherals to their electrical outlets, and turn them on.
14
Install the optional front bezel (if applicable).
15
If the 100-Mbps RAC Ethernet connector on the back of the system has not been used
16
before, you must remove the thin plastic cover that protects the connector.
You can insert your finger underneath the silver strip at the top of the cover to tear
away the cover. See Figure 1-5 for the location of the connector.
Connect a network cable to the RAC Ethernet connector. See Figure 1-5.
17
F i g u r e 1 - 5 .
RAC Ethernet connector
Update the ERA/O card with the latest version of the ERA/O firmware, available at the
18
Dell Support website at support.dell.com.
See the RAC documentation provided on the documentation CD for
information about updating the firmware.
1-6
I n s t a l l i n g o r Re p l a c i n g a n E RA / O C a r d
R A C E t h e r n e t C o n n e c t o r