Setting Of Alarm Thresholds On Measurements - Ht Instruments Hta107 Bedienungsanleitung

Recalling results to the display
1. Press keys  and  at the same time. The indication of the current memory location
–
(see Fig. 2 part 15) flashes on the display.
2. Use keys  or  to change the value of memory location (from 01 to 20) to recall the
corresponding result to the display.
3. Press key MEM/ALM to quit the section and go back to normal measurement display.
Deleting the internal memory
1. Press keys  and  at the same time. The indication of the current memory location
–
(see Fig. 4 left side) flashes on the display.
2. Press and hold keys  and MEM/ALM at the same time for at least 3s. The message
" "
CLR appears on the display and the memory location is automatically brought back to
" "
01 (see Fig. 4

4.3.10. Setting of alarm thresholds on measurements

in measurements of air relative humidity
" MOI INT " and " MOI EXT
Measurement of humidity %RH
1. Press and hold keys RH% and MODE/ZERO at the same time for a few seconds. The
symbol " HIGH "
Fig. 5: Setting of alarm thresholds for %RH measurement
Fig. 4: Deleting the internal memory
–
right side).
" , you can set alarm conditions as follows:
is shown on the top of the display (see Fig. 5
" %RH " and of moisture of materials with contact
EN – 7
HTA107
– left side).