Roborock Saros 10R Bedienungsanleitung Seite 9

Connecting to the App
1. Download the App
Search for "Roborock" in
the App Store or Google
Play or scan the QR code to
download and install the app.
2. Reset WiFi
Press and hold and simultaneously
until you hear the "Resetting WiFi" voice
message. The reset is complete when the
power indicator light flashes blue slowly.
The robot will then wait for a connection.
Note: If you cannot connect to the robot due to your
router configuration, a forgotten password, or any
other reason, reset the WiFi and add your robot as a
new device.
3. Add Device
Open the Roborock app, tap the "Add
Device" or "+" button and add your device
following the in-app guide.
Notes:
• The actual process may vary due to ongoing app
updates. Follow the guide provided in the app.
• Only 2.4 GHz WiFi is supported.
Instructions for Use
C
Filling the Clean Water Tank
C1
Lift the clean water tank, open its lid, and
then fill it with tap water. After filling, close
the lid, lock the latch, and then put the
clean water tank back to the dock.
Notes:
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the
water tank, wipe them with a soft, dry cloth before
reinstalling the tank.
• To prevent a high concentration of cleaning solution,
add solution only to the cleaning solution cartridge.
• To prevent damage, do not use any disinfectant.
Adding Cleaning Solution
C2
1. Remove the dust container cover, pull out
the entire cleaning solution cartridge by
its bottom handle, and then place it on a
hard, flat surface.
Note:
To prevent the dust container cover from falling
and hitting the robot, remove the cover with both
hands, one on each side.
2. Open the lid of the cartridge and add
cleaning solution.
3. Close the lid and put the cartridge back
to the dock. Press the cartridge until you
hear it lock with a click.
4. Install the dust container cover in place to
make sure the dust container is securely
sealed.
008
Notes:
• Make sure that the cleaning solution cartridge is
entirely removed before adding cleaning solution.
• To prevent damage, do not use any disinfectant and
only use cleaning solution recommended by Roborock
in the solution cartridge.
• After adding, the robot will automatically add cleaning
solution to the water for mop washing and robot
water tank refilling according to the preset ratio to
ensure optimal mopping performance.
• Cleaning solution is not included in the package.
Purchase one if needed.
• If no floor cleaning solution is used daily, you may skip
this step or disable Smart Cleaning Solution Filling
in the app.
Turning On/Off
Press and hold to turn on the robot. The
power indicator light will come on, and the
robot will wait for orders.
Press and hold to turn off the robot and
complete the cleaning cycle.
Note: The robot cannot be turned off when it is being
charged.
Starting Cleaning
Press to start cleaning. The robot will
plan its cleaning route and in each room,
it firstly draws out edges and then fills
the room in a zigzag pattern. In so doing,
the robot cleans all rooms one by one,
thoroughly and efficiently.