Roborock Saros 10R Bedienungsanleitung Seite 11

Note: If the robot fails to find the dock, it will
automatically return to its starting position. Place the
robot on the dock manually to recharge.
Error
If an error occurs, the power indicator light
will flash red or status indicator light will be
steady red. A pop-up notification will appear
in the app and a voice alert may sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Resetting the System
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system by removing the magnetic
top cover and pressing the Reset button.
Note: After resetting the system, existing settings such
as scheduled cleaning and WiFi will be restored to
factory settings.
Deactivating WiFi
To disconnect the robot from WiFi, press
the Reset button until you hear a voice
message. Then wait for 5 minutes and the
WiFi will be automatically deactivated. If you
want to reconnect, please follow the related
connecting instructions.
Restoring Factory Settings
If the robot does not function properly after
a system reset, power it on. Press and hold
and at the same time, press the Reset button
until you hear the "Restoring factory settings.
This will take about 5 minutes." voice
message. The robot will then be restored to
factory settings.
Routine Maintenance
D
Notes:
• The product must be switched off and the plug must
be removed from socket outlet before cleaning or
maintaining the product.
• The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
Main Brushes
D1
* Clean every 2 weeks and replace every 6-12 months.
D1-1—Main Brush Cover
D1-2—Main Brush Cover Latches
D1-3—Main Brushes
D1-4—Main Brush Bearings
D1-5— Turn over the robot and press the
two latches inwards to remove the
main brush cover.
D1-6— Lift the main brushes and pull them
out, remove bearings and remove
any entangled hair or dirt at both
ends of the main brushes and
bearings.
010
D1-7— Reinstall the main brush bearings. And
then, reinstall the main brushes and
make sure the color of the main brush,
main brush bearing and the arrow on
the robot match.
D1-8— Reinstall the main brush cover. Make
sure its four teeth are fully seated in
the slots, and press the main brush
cover until you hear it lock with a
click.
Notes:
• It is recommended to wipe the main brushes with a
wet cloth. If the main brushes are wet, air-dry them
away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to
clean the main brushes.
Side Brush
D2
* Clean monthly and replace every 3-6 months.
Unscrew the side brush screw. Remove and
clean the side brush. Then, align the central
groove with the raised position on the robot
and tighten the screw to reinstall the side
brush.
Omnidirectional Wheel
D3
* Clean as required.
D3-1— Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
Note: The omnidirectional wheel bracket cannot be
removed.
D3-2— Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.