Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Main Wheels
D4
* Clean as required.
Clean the main wheels with a soft, dry cloth.
Dustbin
D5
* Clean as required.
D5-1—
Remove the magnetic top cover of
the robot and press the dustbin
latch to take out the dustbin.
D5-2—
Press the cover latch to open the
filter cover and remove the washable
filter, then empty the dustbin.
D5-3—
Fill the dustbin with clean water,
reinstall the washable filter and
close the filter cover. Gently shake
the dustbin, and then pour out the
dirty water.
Note:
To prevent blockage, only use clean water without
any cleaning liquid.
D5-4—
Allow at least 24 hours for the dustbin
and washable filter to dry thoroughly
before reinstalling them.
Washable Filter
D6
* Clean every 2 weeks and replace every 6-12 months.
D6-1—
Open the filter cover and remove
the filter.
D6-2—
Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note:
Do not touch the surface of the filter with hands,
brushes, or hard objects to avoid potential damage.
D6-3—
Allow at least 24 hours for the filter to
dry thoroughly before reinstalling it.
Mop Cloths
D7
* Clean as required and replace every 1-3 months.
D7-1—
Remove the mop cloths from mop
cloth mounts. Clean the mop cloths
and air-dry them.
Note:
A dirty mop cloth will affect the mopping
performance. Clean it before use.
D7-2—
Stick the mop cloths on the mounts
flat in place.
Robot Sensors
D8
* Clean as required.
Use a soft, dry cloth to wipe and clean all
sensors, including:
D8-1—Front Navigation Sensor
D8-2—Wall sensor
D8-3—Communication sensor
D8-4—Rear Navigation Sensor
D8-5—Cliff sensors
D8-6—Carpet sensor
Moving the Dock
D9
To move the dock, grip the power cord
slot on the back with one hand and the
inner side of the front board with the other
hand. Do not lift the dock base, water tank
handles, or dust container cover directly to
prevent the dock from falling off.
011
Dirty Water Tank
D10
* Clean as required.
Open the dirty water tank lid and pour
out the dirty water. Fill the tank with clean
water, close the lid, lock the latch, and
shake. Pour out the dirty water. Lock the lid
and reinstall the tank.
Notes:
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the
water tank, wipe them with a soft, dry cloth before
reinstalling the tank.
Charging Contacts
D11
* Clean as required.
Use a soft, dry cloth to wipe the charging
contacts on the robot and the dock.
Replacing Disposable Dust Bag
D12
* Replace as required.
D12-1—
Remove the dust container cover.
Note:
To prevent the dust container cover from falling
and hitting the robot, remove the cover with both
hands, one on each side.
D12-2—
Remove the disposable dust bag
and discard it.
Notes:
• The dust bag handle seals the bag on removal to
prevent leakage.
• Always install a dust bag before putting back the dust
container cover to avoid auto-emptying without the
bag. You can also disable auto-emptying in the app.
D12-3—
Clean the filter with a dry cloth,
insert a new disposable dust bag
into the slot all the way in, and
spread it evenly.
Werbung
