Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Notes:
• To make sure the robot returns to the dock
automatically, start the robot from the dock and do
not move the dock during cleaning.
• Cleaning cannot start if the battery level is too low.
Allow the robot to charge before starting a cleanup.
• Before cleaning, tidy cords (including the power cord
of the dock) and valuables from the floor. Loose
items may be dragged by the robot, resulting in the
disconnection of electrical appliances or damage of
cords and property.
• If cleaning is completed in less than 10 minutes, the
robot will clean the area twice.
• If the battery runs low during a cleaning cycle, the
robot will automatically return to the dock. After
charging, the robot will resume where it left off.
• The robot will retract mop cloth mounts to clean the
carpet. You can also set the carpet as a no-go zone in
the app to avoid it.
• Before starting each cleaning task, make sure that the
mop cloths have been properly installed.
Spot Cleaning
Press and hold
to start spot cleaning.
Cleaning range: The robot cleans a 1.5 m
(4.9 ft) × 1.5 m (4.9 ft) square area centered
on itself.
Note:
After spot cleaning, the robot will automatically
return to the starting point and wait for orders.
Pause
When the robot is running, press any
button to pause it, press
to resume
cleaning. Press
on a paused robot to
send it back to the dock.
Note:
Placing a paused robot on the dock manually will
end the current cleanup.
Sleep
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
light will flash every few seconds. Press any
button to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left sleep for
more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period, or set whether to enable auto top-
up, emptying and drying, to dim indicator
lights, or lower the volume of the voice
message during the DND period.
Mop Washing
During cleaning, the robot automatically
determines when it should return to
the dock for mop washing and water
tank refilling to maximize its mopping
performance. To manually start washing,
tap the corresponding button in the app.
Press any button to stop washing.
Notes:
• To ensure the robot automatically washes the mop
cloths, start it from the dock and avoid moving the
dock during cleaning.
• To avoid burns from hot water, do not touch the clean
water dispensers.
• Mop wash frequency and mode can be modified in
the app.
009
Emptying
After cleaning, the robot will return to
the dock and auto-emptying will begin
as needed. To manually start emptying,
press
on the docked robot or tap the
corresponding button in the app. Press any
button to stop emptying.
Notes:
• When emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
• Auto-emptying can be disabled in the app.
• Avoid frequent manual emptying.
• Do not use without dustbin, dust container cover, or
disposable dust bag installed in place.
Drying
After mop washing or after cleaning, drying
will begin as needed. To manually start or
stop drying, tap the corresponding button
in the app.
Notes:
• Drying duration can be modified in the app.
• Auto-drying can be disabled in the app.
• Stay away from the drying air outlets during drying.
Charging
After cleaning, the robot will automatically
return to the dock to charge. Press
send the paused robot back to the dock.
The power indicator light will breathe
during robot charging.
to
Werbung
