Num'axes CANICOM 200 Gebrauchsanleitung Seite 27

Checking/Replacing battery of receiver collar
To checkthe conditionof the receivercollar battery,observethe On/Offindicatorlocatedon the front of
the receiver collar:
• Battery fully charged: flashes slowly green.
• Weakbattery:flashesquicklyred.Replace it with a newbattery(See Fitting the batteryin the receiver
collar).
Check the receiver collar operates correctly.
NUWAXES advises to use the same type and same brand of batteries
purchased product. Other brands of batteries
with your product.
You can purchase the suitable batteries
Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog•s skin, enabling the device to operate correctly.
If you have a long-haired
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
How to check that your CANICOM200 is functioning properly
Youcan checkthat your CANICOM 200is operatingcorrectlyat any time.
- Before doing so. make sure that the receiver collar is turned
- Place the neon test lamp in contact with each of the contact points (by unscrewing them then by
screwing them up in order to grip wires of the lamp under the contact points).
- Turn « on » the remote
- Press the « F » or « C » button and modify the level of intensity of the stimulations: the test lamp will
come on with more or less intensity.
Getting the best results
The training instructions you send to your dog are sent from the remote control to the receiver collar by
radio waves. These radio waves are sensitive
(depending on geography and environment).
Gb - 27
may not operate, or may not be completely
from NUM'AXES or from your distributor.
dog and the short contact points fitted to the collar in the factory are inadequate.
control and receiver collar.
as those supplied in your new
off
and the range reaches approximately
compatible
200 meters