Num'axes CANICOM 200 Gebrauchsanleitung Seite 24

IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no
other person is using his CANICOM 200 or other products
receiver collar could accidentally
remote control with the
CODING PROCEDURE FOR THE 1ST USE
1.Activate the remote control: press for 1 second the On/Off red button
remote control.
2. Activate the receiver collar: approach the red indicator located on the remote control until coming in
contact on red indicator located on the receiver collar. hold for 1 second.
3. Move the remote control away from the receiver collar.
4. Press the button of the remote control. A beep sound is emitted, the collar is then synchronized with
your remote control.
RE-CODING PROCEDURE(for all codings other than the 1st)
1. Activate the remote control: press for 1 second the On/Off red button lid)) located on the side of the
remote control.
Receiver collar in position « deactivate » (indicator off): approach the red indicator located on the
2.
remote control until coming in contact on red indicator located on the receiver collar. hold for
seconds. The indicator lights in fixed green. then flashes in red.
3. Move the remote control away from the receiver collar.
4. Press the button< of the remote control. A beep sound is emitted, the collar is then synchronized
with your remote control.
Reprogram a receiver collar
Collar can be re-coded indefinitely,
remote control.
Ref. Re-coding procedure.
How to use the remote
The CANICOM200 remote control is designed to operate with 1 receiver collar.
button: beeper
If you press the « Beeper » button
this function: the beeper will continue to sound for as long as the button is pressed.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light on the
collar goes from flashing green to permanent green for as long as the button is pressed.
Gb - 24
record the code of his remote control.
receiver collar.
either with the same remote
control
the receiver collar will emit sound signals. There is no time limit for
from the range close by: your
If that occurs, re-code
located on the side of the
control, or with
the
new CANICOM