Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGL ISH
Thank you for choosing our ceiling fan. Before using this appliance and to ensure its best
use, please read the instructions carefully.
The safety measures listed here reduce the risk of fire, electric shock and injury when
followed correctly. Keep the manual in a safe place for future reference, as well as the
purchase receipt and box. If applicable, give these instructions to the future owner of the
appliance.
Always follow basic safety instructions and risk prevention measures when using an
electrical appliance. The manufacturer shall not be liable for any damage resulting from the
user's failure to comply with these instructions.
LOCATION AND INSTALLATION REQUIREMENTS
M EC HAN I CAL T IP S
• According to safety regulations, the lowest point of the fan blades must be at least 2.3
metres from the ground.
• Make sure the chosen location does not allow the rotating blades to come into contact with
any objects.
• Check that the ceiling joists are secure and large and strong enough to support the weight
of the fan.
• To reduce the risk of fire, electric shock, or personal injury, ensure that the fan mounting
bracket is attached directly to the building structure. Do not mount in a distribution box.
• The mounting bracket must be securely bolted to a supporting structure such as a concrete
ceiling, steel structure, or wood frame. If a wooden frame is added, it should be nailed or
screwed securely between two joists.
• To reduce the risk of personal injury and property damage, do not bend or damage the
downrod or fan blades when handling or installing the fan. If you notice any damage to the
product, please contact our after-sales service before proceeding to install the fan.
• Make sure the fan is securely attached to the ceiling. All fixing screws should be checked
and re-tightened whenever necessary before starting the fan.
E LECTRI CAL TI P S
• Turn off the power before performing any work on the ceiling fan and turn off the power
supply circuit breaker. To avoid possible electrical shock, make sure the power is off at the
fuse box or circuit breaker panel before proceeding with wiring.
• The fan, mounting bracket and lighting equipment must be connected to a grounded outlet.
Check that all joints are well insulated.
• Check and confirm that all connections are correct and secure. Once all electrical connec-
tions have been made, store all cables neatly.
• Do not attempt to control this fan from a wall switch or remote control that is not approved
by the manufacturer for use with the fan. Do not use a solid state driver. Using a non-ap-
proved wall switch or remote control will void the warranty.
• Do not connect the ceiling fan to a dimmer switch.
E NGL I SH
6
Werbung
