EuroLite AKKU IP UP-4 QCL Spot QuickDMX MK2 Bedienungsanleitung Seite 33

POWER SUPPLY
The device can be operated with mains voltage and for mobile use via the internal rechargeable battery.
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts. The
power connectors are designed according to protection class IP65. Matching connection cables with special
plugs are optionally available. When not in use, make absolutely sure to close the connections with the
rubber sealing caps to prevent moisture and dirt from penetrating.
1 Connect the device via the mains cable to a grounded mains socket.
2 To switch on the unit, press the power button.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
Charging the rechargeable battery
Prior to operating the device off mains for the first time, the rechargeable battery must be fully charged. You
can charge the product using the power cable.
1 The operating time of the battery depends on the operating mode and the ambient temperature (max.
5.5 hours). After the operation, switch the device off.
2 For charging the battery, connect the device to a power outlet via the power cable provided. Charging
time is 3 hours. The device may be operated during the charging procedure.
3 The device features a protective circuit for charging which prevents overload of the rechargeable battery.
However, disconnect the device from the mains after charging. Otherwise there will be a low current
consumption even if the device is switched off.
4 The device will heat up during charging; this is normal.
5 To prevent damage to the battery by deep discharge, recharge a completely discharged battery as soon
as possible. Do not store the unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Maximum battery run time
5.5 hours
Battery status
The battery charge status is indicated on the display. The display shows the battery charge status in %. If the
display shows 100%, the battery is fully charged. If the display shows 20% or less, the battery will be going
flat soon and must be charged. In this state, the device can be operated for a few minutes. The estimated
remaining runtime, depending on the selected operating and battery mode, is shown on the display. Then an
emergency switch-off deactivates the device to protect it from total discharge. Please note, that it may take a
few seconds after changing the device settings for the remaining runtime to be recalculated and displayed.
Recharge time
3 hours
33/44
00159907, Version 1.0