EuroLite AKKU IP UP-4 QCL Spot QuickDMX MK2 Bedienungsanleitung Seite 30

INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must
never be fixed swinging freely in the room.
Placing the device
Place the product as desired and adjust the tilt angle via the folding foot.
Fixing to a truss
1 The rigging structure must support at least 10 times the
weight of all fixtures to be installed on it.
2 Block access below the work area and work from a
stable platform when installing the device.
3 Use rigging hardware that is compatible with the
structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a
list of suitable rigging hardware.
4 Screw a coupler via an M10 screw and self-locking nut
onto the Omega bracket. Insert the two screws of the
enclosed Omega bracket by using a circlip for each
screw into the respective holes on the bottom of the
device. Tighten the screws fully.
5 Secure the device with a safety bond or other secondary
attachment. This secondary safety attachment must be
sufficiently dimensioned in accordance with the latest
industrial safety regulations and constructed in a way
that no part of the installation can fall down if the main
attachment fails. An appropriate eyelet is mounted on
the device for fixation of the safety bond. Fasten the
safety bond in such a way that, in the event of a fall, the
maximum drop distance of the device will not exceed 20
cm.
6 After installation, the device requires inspections
periodically to prevent the possibility of corrosion,
deformation and looseness.
Changing the beam angle
For a homogeneous and soft light of the uplight, please use the enclosed frost filter. Simply fix this filter over
the lenses with the enclosed knurled head screws.
30/44
00159907, Version 1.0