GB
knowledge of the product unless they are
supervised, or have been instructed on
how to use the product, by a person
responsible for their safety.
• Ensure that children are not able to play
with the device.
• Always comply with all applicable domes-
tic and international safety, health, and
working regulations.
Electrical safety
• The device may only be connected to a
socket that is correctly installed and
grounded.
• The fuse must be a residual current cir-
cuit-breaker with a measured residual
current of no more than 30 mA.
• Make sure that the power supply corre-
sponds with the connection specifications
of the device before it is connected.
• The device may only be used within the
specified limitations for voltage and power
(see type plate).
• Do not touch the mains plug with wet
hands! Always pull out the mains plug at
the plug and not by the cable.
• Do not bend, crush, pull or drive over the
power cable, protect from sharp edges, oil
and heat.
• Do not lift the device using the cable or
use the cable for purposes other than
intended.
• Check the plug and cable before each
use.
• If the power cable is damaged immedi-
ately disconnect the plug. Never use the
device if the power cable is damaged.
• If the device is not in use make sure the
plug is pulled out.
• Make sure that the device is switched off
before plugging in the mains cable.
• Make sure that the device is switched off
before unplugging it.
• Disconnect the power supply before
transporting the device.
Maintenance
• Before conducting any maintenance on
the device, disconnect the mains plug.
• Only those maintenance and fault elimi-
nation tasks described here may be car-
ried out. Any other tasks must be com-
pleted by a specialist.
• Only use original replacement parts. Only
these replacement parts are designed
and suitable for the device. Other replace-
28
ment parts will not only lead to an invalida-
tion of the warranty, they may also endan-
ger you and your environment.
Device-specific safety instructions
• Pay attention when walking backwards.
Danger of stumbling!
• Pay attention to local regulations for rest
periods.
• Remember that moving parts may also be
located behind ventilation and venting
slots.
• Symbols affixed to your tools may not be
removed or covered. Information on the
device that is no longer legible must be
replaced immediately.
Observe the safety instructions before
using the product for the first time.
Risk of injury due to electrical power!
Read and observe the operating in-
structions before commissioning.
Danger due to foreign bodies being
thrown out.
Always ensure sufficient safety dis-
tance is held.
Keep cables well away from the unit.
Risk of injury due to cutting mechanism!
Never reach into the cutting mecha-
nism.
Before doing any maintenance and
repair work disconnect the machine
from the power.
Personal protective clothing
Wear ear defenders
Wear safety shoes
Wear safety goggles
Wear protective gloves