SAFETY
The following signal words are used in this quick guide:
Warning!
serious injury if not avoided.
Please note!
General safety instructions
Charging at a temperature below 10 °C causes chemical damage to the cell
and can lead to a fire.
• Charge the battery at room temperature.
Improper charging and discharging can disproportionately impair the
performance of the battery.
• Fully charge the battery before using the device for the first time.
• Fully recharge the empty battery within 12 hours.
• Fully charge the battery at least once every three months, even if the
device has not been in use during this time.
• Only charge the battery when the charging socket is clean and dry to avoid
corrosion. Damage to the charging pins is not covered by the warranty.
DESCRIPTION
The battery-operated swimming pool cleaner carries out the maintenance
cleaning of your filled pool in automatic mode. The removable filter unit filters
the water and collects deposits from the pool.
PREPARATION
1. Assemble the device (Figure 1)
Please note!
1. Attach both ends of the inner handle to the upper part of the robot.
2. Attach the inner handle to the upper part of the robot with four screws and
tighten them firmly.
3. Engage the outer handle until you hear a click.
2. Charging process
1. Switch off the device before charging.
The on/off button is located on the underside of the device.
2. Connect the charger to the device.
The charging socket is located on the underside of the device.
3. Plug the charger into a socket.
The charging indicator light lights up red. The battery is charging. The
charging indicator light is green. The battery is fully charged.
4. Disconnect the charger from the power supply and the device.
This signal symbol/word indicates a hazard with a
medium level of risk, which, can result in death or
This signal word warns of possible material damage.
Warning!
Fire hazard!
Please note!
Please note that once the handle has been
reassembled, the right to return the appliance
expires.