Spectrum NX10+ Bedienungsanleitung Seite 43

Monitor
The Monitor screen displays the servo positions for each channel
graphically and numerically. This is useful to verify programming
functions, trim settings, mix directions, etc. The numeric value
is directly relative to the travel adjust and mix values (e.g. 100%
travel adjust equals 100% value in the Monitor).
Scroll past the main monitor to view the X-Plus Monitor, which
shows up to channel 20.
The following menu options are only available when they are enabled from the Model Type screen.
(Aileron) Differential
Only available in Acro and Sailplane Type when a dual aileron servo wing type is active. See Acro (Airplane) section for set up.
V-Tail Differential
Only available in Acro and Sailplane Type when V-Tail A or V-Tail B is active. See Acro (Airplane) section for set up.
Camber Preset
Only available in Sailplane Type when a 2+ aileron wing type is selected. See SAIL (Sailplane) section for set up.
Camber System
Only available in Sailplane Type when a 2+ aileron wing type is selected. See SAIL (Sailplane) section for set up.
Flap System
Only available in Airplane Type when a flap-enabled wing type is selected. See ACRO (Airplane) section for set up.
Pitch Curve
Only available in Helicopter Type. See HELI (Helicopter) section for set up.
Swashplate
Only available in Helicopter Type. See HELI (Helicopter) section for set up.
Gyro
Only available in Helicopter Type. See HELI (Helicopter) section for set up.
Tail Curve
Only available in Helicopter Type. See HELI (Helicopter) section for set up.
Motor Cut
Only available in Multicopter Type. See MULTI (Multicopter) section for set up.
Motor Curve
Only available in Multicopter Type. See MULTI (Multicopter) section for set up.
ACRO (AIRPLANE)
CAUTION: Always do a Control Test of your model with the transmitter after programming to make sure your model responds
as desired.
NOTICE: Refer to your airplane manual for recommended control throws.
SPEKTRUM NX10 + • TRANSMITTER INSTRUCTION MANUAL
www.modellmarkt24.ch
EN
43