Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Depth stop (Fig. 3)
The depth stop (1) is held by clamping with the quick-re-
lease fastener (a) on the additional handle (7).
• Press the quick-release fastener (a) and insert the
depth stop (1).
• Bring the depth stop (1) to the same level as the drill.
• Pull back the depth stop (1) by the desired drilling
depth.
• Release the quick-release fastener (a) to clamp the
depth stop (1).
• Now drill the hole until the depth stop (1) touches
the workpiece.
Inserting the tool (Fig. 4)
• Clean tool before use and lightly grease tool shaft
with drill grease.
• Pull back the locking sleeve (8) and hold in place.
• Push the dust-free tool into the tool receiver up to the
stop while rotating it. The tool will lock itself in place.
• Check the locking mechanism by pulling on the tool.
Removing the tool (Fig. 5)
Pull back the locking sleeve (8) and hold it in place and
remove the tool.
Dust collection device (Fig. 6)
Before hammer drill work, slide the dust collection de-
vice (I) vertically over the drill.
Inserting the chuck (Fig.8)
To insert the supplied chuck (J), follow the sequence
under point "Inserting the tool"
10. Start up
Danger!
In order to prevent a hazard, the machine may only
be held by the two handles (4/7)! Otherwise there is
a risk of electric shock if a cable is drilled into!
Switching off: Release on/off switch (3).
Locking: For hand and finger relief, lock the on/off
switch (3) by pressing the switch lock (10).
Hammer-drilling/chiselling selector switch (Fig. 7)
• For drilling, press the button (e) on the rotary switch
(2) and at the same time turn the rotary switch (2) to
the switch setting (f).
• For hammer drilling, press the button (e) on the ro-
tary switch (2) and at the same time turn the rotary
switch (2) to the switch setting (c).
• For chiselling, press the button (e) on the rotary
switch (2) and at the same time turn the rotary switch
(2) to the switch setting (d). The chisel is not locked
in position (d).
• For chiselling, press the button (e) on the rotary
switch (2) and at the same time turn the rotary switch
(2) to the switch setting (g). The chisel is locked in
position (g).
Note!
Only a low pressing force is necessary for percussion
drilling. Too much pressing force puts unnecessary
strain on the motor. Check the drill regularly. Sharpen
or replace blunt drills.
11. Electrical connection
The electrical motor installed is connected and ready
for operation. The connection complies with the appli-
cable VDE and DIN provisions.
The customer's mains connection as well as the ex-
tension cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables of the same designation.
GB | 23
Werbung
