Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembling
0
0
NOT
Note:
Before attaching the pedestal and legs to the piano, rest the piano on its back, with the rear panel resting
on the floor. For safe and secure assembly, enlist the aid of another person when performing the following
steps.
Usethe longscrews(PartA) to attachthe metalbrackets (Part@)to the top of the pedestal ( PartO). Make
1.
sure that the protruding parts of the bracket are on the same side as the pedals.
Screwthe front legs(Part@)intothe metalplateson the underside o f the piano(Part@)underthe corners
2.
of the keyboard.
3.
Fit the two screws protruding from the underside of the piano into the forward holes in the metal brackets,
slide the piano forward, and lock it into position with the four wing nuts (Part B).
4.
Fit the connector at the end of the pedal harness (Part@) into the matching connector on the underside of
the piano.
With the aid of another person. set the piano upright.
5.
6.
Adjust the knobs at the end of the legs and under the pedestal until the piano stands firmly on the floor.
NDte: A wobbly piano is not only more difficult to play, it may introduce excessive vibration to the sound.
Keyboard
Cover.
The keyboard cover folds down to
cover the entire keyboard.
damaging it and the keyboard:
the
Stand
B
US E
M6
SPANNéZ
To avoid
• Always grasp the cover in the
middle when lifting.
• Never
force
the cover
in or
out.
Pedestal
(viewed from
above)
•
Music
Stand
To prop up the music stand, pull out the flaps and fit them into
Front
(See
"lustration.)
3
Werbung
