Protector ASK-6030 Bedienungsanleitung Seite 19

CODING THE EXHAUST CONTROL
Preparation
Connect the sensor cable to the oven
transmitter. On the back of the oven
transmitter, there are two screw terminals
marked RED and BLACK. Loosen both
screws and connect the red cable to the
RED terminal and the black cable to the
BLACK terminal. Tighten the screws securely.
The wireless transmitters are not pre-coded
and must be paired with the receiver before
first use. Follow these steps in order:
1. Connect the receiver to the power
supply. The "Status" LED (2) will blink red
for 20 seconds and then turn off.
2. Hold the CODE button (3) on the receiver
for 2 seconds until the "Status" LED (2)
starts blinking red.
3. Activate the transmitter by pressing the
pressure switch. The "Status" LED (2) on
the receiver will light up red, completing
the pairing process.
4. Insert batteries (2x AA) into the oven
transmitter (8). The LEDs (9 and 11) will
briefly light up.
5. Hold the CODE button (3) on the receiver
for 2 seconds again, and the "Status"
LED (2) will blink.
6. Activate the oven transmitter (8) by
pressing the status button (13). The
built-in LEDs will light up, and the
"Status" LED (2) on the receiver will light
up green, completing the pairing
process.
NOTE
After each power outage, the receiver enters
learning mode for 30 seconds. If no new
window transmitter is paired, the previous
coding remains active.
PAIRING ADDITIONAL TRANSMITTERS
NOTE
Additional transmitters are paired with an
"OR" function. This means window "1" OR
window "2" can be opened to activate the
exhaust control. Similarly, oven transmitter
"1" OR oven transmitter "2" can disable the
exhaust control.
Adding a Window Transmitter
Repeat steps 2 and 3 from the "Coding the
Exhaust Control" section.
Adding an Oven Transmitter
Repeat steps 5 and 6 from the "Coding the
Exhaust Control" section.
DELETING SINGLE OR ALL
TRANSMITTERS
Deleting a Single Transmitter
1. Hold the button (3) on the receiver for
2 seconds. The LED (2) will start blinking.
2. Activate the transmitter you want
to delete.
3. The blinking LED (2) on the receiver
will stop, indicating the deletion of
the single transmitter is complete.
Deleting All Transmitters (Factory Reset)
1. Hold the button (3) on the receiver for
2 seconds. The LED (2) will start blinking.
2. Hold the button (3) again for 2 seconds.
The blinking LED (2) on the receiver will
stop, indicating that all transmitters
have been deleted.
19
ASK-6030
GB
GB