Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Power Button Indicator
Power Button
Meaning
Indicator
Standby
Solid green
The machine
runs properly.
Liquid level in
Flashing green
the tank reaches
6 times, then
the bottom tip
shuts off.
of the liquid
sensors
Flashing green
Electronics error
continuously
SPEED SELECTION
Regular Speed Mode
◾
Every time the speed adjustment button is pressed, the
speed will toggle between low level and high level. The
speed indicator displays green lights corresponding to
the current speed level.
◾
The vacuum will save the last speed setting and will
revert to it upon restart.
TURBO MODE
◾
Press the TURBO button, the TURBO indicator will light
up green and the vacuum will start working directly at
TURBO speed, i.e. the highest speed.
◾
When in TURBO mode, press TURBO button again,
or press the speed adjustment button, the start/stop
button, or the power button – the TURBO indicator will
turn off and the vacuum will exit TURBO mode.
NOTE:
After exiting TURBO mode, the vacuum will
resume previously active regular speed.
SUCTION REGULATOR (Fig. I)
When vacuuming, the air flow at the end of the vacuum
hose can be controlled by turning the suction regulator.
Turn the regulator to expose the air outlet to decrease
the suction, or turn the regulator to cover the air outlet to
increase the suction.
56 VOLT LITHIUM-ION CORDLESS WET/DRY VACUUM — WDV0900E
This feature is especially useful when the vacuum hose
is sealed by carpets, cloths, etc. during suction, turn the
regulator to expose the air outlet, the suction will be
Action
decreased.
No actions
I-1 Suction Regulator
required. The
vacuum will turn off
automatically after
REMOTE CONTROL
1 hour of inactivity
◾
The remote control could be positioned on the vacuum
Normal operation.
hose during vacuuming (Fig. J1).
◾
When the vacuum is powered on, you may start/stop
Stop the vacuum,
the vacuum, or switch the machine into TURBO mode
remove the
by using the remote control.
battery pack, and
NOTE:
then empty the
tank referring
low or high speed.
to the emptying
◾
The remote control can also be used as a flashlight for
instruction.
dark areas, especially when using the crevice nozzle.
Contact EGO
Remote Control Pairing (Fig. J2)
customer service
The remote control was paired with the vacuum at the
for help
factory. However, in cases when the remote control is
damaged or lost, follow below steps to pair your new remote
control with the vacuum.
1. Install the battery pack.
2. Press the power button to power up the vacuum.
3. Long-press the start/stop button on the vacuum until
the power button indicator flashes green slowly.
4. Press the TURBO button or the start/stop button on the
remote control as soon as the power button indicator
starts flashing green slowing.
5. The power button indicator will flash green fast and
then shine solid green to indicate the pairing was
successful.
Remote Control Indicator
Remote
Control
Indicator
Flashing
green fast
Flashing
green slowly
Solid green
I-2 Air Outlet
The remote control cannot switch between regular
Meaning
Action
The remote control
Charge the remote
battery charge is
control.
nearly depleted.
The remote control
No action needed.
is charging.
Disconnect the
The charging of
remote control and
the remote control
charging cable
is complete.
from power supply.
EN
11
Werbung
