Cleaning The Pool - Steinbach Poolrunner One Rxb 150 Originalbetriebsanleitung

Cleaning the pool

Observe the following before cleaning your pool:
- Remove any cover or foil from the pool.
- Remove obstacles (such as a ladder) from the pool.
- Switch off the filter system at least one hour before the start of cleaning so that particles in the
water can settle on the floor.
Proceed as follows to clean your pool:
1. Insert the filter unit.
2. Place the device in the pool and switch it on.
Inserting the filter unit
5
5
6
12
1. Insert the filter unit
point in the same direction as the arrows on the bottom part
2. Close all clips
12
The filter unit is inserted.
Placing the device in the pool and starting cleaning
6
1. Hold the device by the handle
the air has escaped.
2. Press the ON/OFF switch
If the ON/OFF switch is pressed when the device is not in the water, it beeps and does not turn on.
The device switches on 15 seconds after it is lowered into the water.
3. Then let the device sink to the bottom of the pool.
Make sure that the device lands on the bottom of the pool on its underside and that cleaning can
start without obstruction towards the center of the pool.
The device is in the pool and starts cleaning with a time delay.
24
correctly into the bottom section
5
.
and lower it slowly into the water (tipped slightly forward) until all
10
for 3 seconds. The appliance starts to beep.
15
. The arrows on the filter unit
6
.
6
7
15
must
5