Error Codes - Inventum Vvw6008Aw Benutzerhandbuch

Problem
There are white stains on
the dishes.
The dishes are not dry.
There are rust stains on the
washed items.

ERROR CODES

In case of a fault in the appliance, the start/pause button or one or more programme step indicators will flash.
Error
Refilling takes too long
Pressure system defective
Water supply does not stop -
Draining takes too long
Heating element and
sensor defective
Overflow/leaks
Circuit board defective
Overheating
Heating not successful
High voltage
Low voltage
Possible cause
The amount of dishwasher detergent is
not enough.
The rinsing agent consumption has been
set too low.
The water hardness level is high and no salt
is being used.
The cap of the salt reservoir has not been
closed correctly.
The programme selected does not have
a drying process.
The rinsing agent consumption has been
set too low.
The quality of the stainless steel items is
insufficient.
The water has a high salt content.
The cap of the salt reservoir has not been
closed correctly.
Salt spilled while filling the salt reservoir has
not been removed immediately.
There is a problem with the earthing of the
mains supply.
Start/pause Washing
button
- -
Flashing -
Flashing -
-
Flashing -
Flashing Flashing
- Flashing
Flashing Flashing
Flashing -
- Flashing
Flashing Flashing
- Flashing
Possible solution
Ensure that you fill the dishwasher
detergent reservoir with sufficient
dishwasher detergent.
See section Filling the dishwasher detergent
reservoir.
Adjust the rinsing agent consumption.
See section Setting the rinsing agent
consumption.
Fill the salt reservoir.
See section Filling the salt reservoir.
Ensure that the cap of the salt reservoir
is sufficiently tightened.
Select a programme with a drying process.
See section Programmes.
Adjust the rinsing agent consumption.
See section Setting the rinsing agent
consumption.
Ensure that you only clean dishwasher safe
items in the appliance.
Adjust the salt consumption.
See section Setting the salt consumption.
Ensure that the cap of the salt reservoir is
sufficiently tightened.
Make sure you immediately remove spilled
salt and run a complete programme to
prevent corrosion.
Contact a recognised electrician.
Drying End
Flashing -
- -
- -
- Flashing
- Flashing
- -
- Flashing
Flashing Flashing
Flashing -
Flashing -
Flashing -
Flashing Flashing
Notes
Check if the tap is open and if the
water is flowing.
Close the tap and remove the supply
hose. Check if the filter is clogged. a
Contact customer service.
Close the tap and contact customer
service.
Cancel the programme and clean
the water supply hose and filters.
Contact customer service.
During normal operation, only leaks
are indicated.
Contact customer service.
Contact customer service.
During normal operation, this error
is only shown at the end of
a programme.
Contact customer service.
Contact customer service.
English
43
•