EuroLite AKKU IP BAR-6 Entry Bedienungsanleitung Seite 34

Strobe effect
FLASH mode enables strobe effects. The flash frequency is adjustable.
1 Press the MENU button until FLASH is indicated in the display Confirm with the ENTER button.
2 Use the buttons UP and DOWN to adjust the desired speed (00-99). Confirm with the ENTER button.
Behavior at missing DMX-signal
In DMX lost mode the program offers different options when no DMX signal is received.
1 Press the MENU button repeatedly until the display shows the DMX lost menu. Press ENTER to
confirm.
2 Select the desired program with the UP and DOWN buttons (see Menu structure). Confirm with ENTER.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button until SLAVE is
indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
Master/slave operation via QuickDMX
1 Set the master device and each slave device to the same transmission channel using the function SET
2.4G. Thus, the spotlights are paired.
2 Set the master unit to the desired operating mode and all slave units to SLAVE mode. The devices will
now operate in sync.
Akku mode
The BATTERY mode offers the possibility to adjust the battery runtime.
1 Press the MENU button until BATTERY is indicated in the display. Confirm with the ENTER button.
2 Use the buttons UP and DOWN to choose Super for Super bright mode, Normal for Normal mode, or
Economy for Energy save mode. Confirm with the ENTER button.
Key lock
Enable or disenable the lock passcode on the display screen.
With PASSCODE function you can lock the keys of the Control Board to e.g. prevent menu tampering. If this
function is activated, the keys will be automatically locked from the last command. In order to deactivate the
keylock function, press these keys in the following order: UP, DOWN, UP, DOWN, ENTER.
QuickDMX transmission channel
You can use the SET 2.4G menu to set the wireless transmission channel for QuickDMX operation. Please
refer to the corresponding chapters for further explanation.
34/40
00156821, Version 1.1