Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remove transport packaging
The appliance and the interior fittings are protected for transport.
1. Pull off the adhesive tape on the left and right side of the door.
2. Remove all adhesive tape and packing pieces from the interior of the
appliance.
Installation
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use and efficient performance of the appliance is affected
by the ambient temperature.
The appliance should therefore
– not be exposed to direct sunlight;
– not be installed next to radiators, cookers or other sources of heat;
– only be installed at a location whose ambient temperature cor-
responds to the climate classification, for which the appliance is
designed.
The climate classification can be found on the rating plate, which
is located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct
for each climate classification:
Climate classification
SN
N
ST
T
Installation directly under a hob is not allowed. The temperatures of
the hob, which in part are quite high, may damage the appliance. If a
hob is installed near the appliance, the corresponding installation and
safety instructions must be adhered to. Considering the numerous in-
stallation conditions which are possible, there is no way of providing
detailed information here.It is necessary to avoid overheating of the
appliance by maintaining adequate distances from heat sources and by
the use of a suitable thermal insulation plate. Proper ventilation of
the appliance must also be ensured.
for an ambient temperature of
from + 10 at 32°C
from + 16 at 32°C
from + 18 at 38°C
from + 18 at 43°C
7
Werbung
Kapitel
Inhaltsverzeichnis
