VEVOR RN-QYR-7500 Bedienungsanleitung Seite 7

HOOKING UP TO TOWED VEHICLE
1. Position the towing vehicle on a level surface with a straight driveway
ahead and engage the parking brake. Position the towed vehicle behind
the towing vehicle in the approximate towing position.
2. Partially extend one leg. The legs are held in with an internal "soft" latch.
Pulling out on the leg will disengage this latch. Place the triple lug between
the attachment tabs on the baseplate, and secure it with the pin and quick
pin. Be sure the pin is installed correctly through the attachment tab with
the nose towards middle of the baseplate. Repeat for both legs.
3. On the towed vehicle, disengage the parking brake, set up the
transmission for towing and unlock the steering wheel. Pull forward with
the towing vehicle until one or both of the locking handles are engaged and
locked (When locked they will "pop" up). If only one locking handle is
locked, turn the towed vehicle's steering wheel towards the unlocked tow
bar leg approximately 1/2 to 3/4 turn, before continuing forward. Drive the
towing vehicle forward until the second leg locks into place.
IMPORTANT: Check to ensure both legs are latched properly and pins are
secured properly before towing. When properly installed the quick pin ring
will snap back onto itself, and the chamfered side will be facing outwards.
The steering wheel on the towed vehicle must be unlocked at all times
while being towed. Failure to do so will create hazardous driving
conditions.
☑
☒
- 6 -