VEVOR RN-QYR-7500 Bedienungsanleitung Seite 4

11. Do not use the towed vehicle for storing luggage, etc., which may
cause you to exceed the towing capacity of the tow bar, baseplate, and its
accessories.
12. Ensure that your towing vehicle is of adequate size to properly control
your towed vehicle. The weight and braking capacity should be large
enough to handle both vehicles in an emergency situation. Check your
towing vehicle manufacturer's recommendations for towing, hitch load, and
braking capacities. The hitch, ball, motor home chassis, and safety cables
(each individual cable) need to be rated at a minimum for the weight of the
vehicle being towed.
CAUTION
As with any mechanical product, care should be taken during installation
and operation to prevent your fingers from being pinched.
Slide the hitch connector into the receiver tube of your towing vehicle hitch.
Install the receiver pin provided into one of the two holes of the hitch
receiver. The inside hole of the receiver tube is most commonly used.
NOTE: The configuration of the rear of your towing vehicle will determine
how far you can slide the hitch connector into the receiver tube. Later,
when the tow bar is folded, you may need to change which set of holes are
used in the hitch connector or order a longer hitch connector.
CAUTION
It is important that the attachment points at the center of the attachment
tabs and the center of the coach's hitch receiver should be of equal
distance. If a deviation must occur, then it is recommended that the hitch
receiver be no more than 3" above or below the attachment tabs of the
baseplate.
INSTALLATION
- 3 -