The devices have to be initialised. Only after this can the fingerprints be saved. Proceed as follows:
T
STAR
DISPLAY
KEY STOKE
B:
ENTERING THE SECURITY CODE
The security code is used to prevent unauthorised people having access to your system and thereby changing data. The factory setting for the code is "99": change this code straight after starting-up the system
in order to ensure protection from manipulation. The necessary entries to change the code can be found in section
DISPLAY
KEY SROKE
T
STAR
C:
CHANGE THE SECURITY CODE (Sc)
Enter the security
DISPLAY +
T
STAR
SETTING
code
SEE
B:
Select the MENU
POINT Sc
D:
RESET TO FACTORY SETTING (rr)
Enter the security
DISPLAY +
STAR
T
SETTING
code
SEE
B:
Select the
MENU POINT rr
E:
SWITCHING TIMES OF THE RELAYS (rt) – The switching time of each individual relay can be set from 1 sec. to 99 sec. If 0 is set then the relay works in bistable mode.