eKey home Kurzanleitung Seite 6

START-UP
Proceed as follows to start-up the device:
8.) Mount the devices in accordance with the supplied assembly
instructions
9.) Connect the wires in accordance with the wiring plan. (Contained in
the assembly instructions)
WARNING ! Do not yet connect the system to the mains!
The electrical connection of the system can only be carried
out by a specialist.
10.) Check the wiring.
11.) Close all the device casings properly, which you have to open
for the wiring.
12.) Make sure you study the chapter
scanner" below. The correct operation (swiping the finger
over the sensor) of the fingerprint scanner is decisive for
the functioning of the whole system. Also see the film in
folder "Tips&Tricks" on the supplied DVD.
13.) Connect the power adaptor to the mains.
The ekey home control panel starts to count down from 44 in one
second intervals and after around 5 seconds two red dots light up.
The status display on the fingerprint scanner flashes yellow:
14.) Now start at point A: INITIALISE DEVICES of "Programming
the System"
"Operating the fingerprint
PROGRAMING THE SYSTEM
LED-DISPLAYS ON THE FINGERPRINT SCANNER
LED- statuses are displayed as follows:
LED
POSITION
IMPORTANT OPTICAL
SIGNALS ON THE
FINGERPRINT SCANNER
FINGERPR Status Function
INT display display
SCANNER
standard
Orange
light Off
flashing
Left: green
Off
Right: green
Orange
Left: green
light
Right: green
flashing
Red/green
Left: green
light
Right: green
flashing
LED-DISPLAYS AND THE OPERATING ELEMENTS OF THE CONTROL PANEL
The control panel has 4 buttons for operation and programming and a LED display to
support in the menu navigation and the reporting of status information.
Symbol for the seven-segment display on the
CONTROL PANEL
This shows what is being displayed during the programming
process and operation on the control panel.
Symbol for a key stroke on the CONTROL PANEL
Shows
programming process. The key to be pressed is marked red.
Is used to enter the menu and confirm entry
OK =
> < Are used to change the values on the display
ESC = X Is used to cancel the current entry
Symbol: The LED statuses shown on the
fingerprint scanner (standard) during the
programming process and normal mode.
Red light on Orange light on
Red light
Orange light flashing
flashing
Red/green
Green light on
flashing
Green light
flashing
Description
There is no connection to the
TOCAhome control panel. Please check the
electrical connections or carry out the start-
up procedure.
The system is online – all the components
are communicating correctly.
Fingerprint recognition: check in progress
Firmware update in progress (with the
program TOCAUpdate)
T
that a key stroke is necessary
Key functions and allocation
light
®
ekey
during the