Herunterladen Inhalt Inhalt Diese Seite drucken

Programmierung; Programmierung Mit Motorola-Zentralen - Viessmann 5240 Bedienungsanleitung

N lokdecoder
Vorschau ausblenden Andere Handbücher für 5240:
Inhaltsverzeichnis

Werbung

Abb. 4
Anschluss von SUSI-Modulen / Wiring SUSI modules
Im DCC-Format können Sie diese Konfigurati-
onsvariablen (CVs) programmieren. Die „Haupt-
gleisprogrammierung" (POM) ist ebenfalls mög-
lich. Im Motorola-Format werden die Einstellungen
in sogenannte Register programmiert, die Zähl-
weise ist mit der der CVs identisch.
Programmierung mit DCC-Zentralen
Von der Zentrale aus können Sie die Konfigurati-
onsvariablen (CVs) des Decoders programmieren.
Beachten Sie dazu den betreffenden Abschnitt in
der Bedienungsanleitung Ihrer Zentrale, in der die
byteweise Programmierung der CV-Variablen be-
schrieben ist.

Programmierung mit Motorola-Zentralen

Stellen Sie die Lok auf ein Gleis, das mit dem
Gleisausgang der Zentrale verbunden ist. Es darf
kein weiteres Fahrzeug auf dem Gleis stehen, da
der darin befindliche Decoder sonst ggf. ebenfalls
programmiert wird.
SUSI PLUS
SUSI CLOCK
SUSI DATA
SUSI GROUND
Widerstand / Resistor
10 ... 100 Ohm
Type 0207 oder 0411
Elko -
+
Elektrolytkondensator
Electrolytic Capacitor
100 - 470 µF / >25 V
Typ 1N4001 o. ä.
Type 1N4001
Diode
locomotive confirms the change into the program-
ming mode and the acceptance of programming
commands by flashing the lights.
In DCC format you can program the configuration
variables (CVs). This can also be done by "Pro-
gramming on the Main" (POM).
In the Motorola format the settings are saved in
so called registers. The method of counting is the
same as with the CVs.
Programming with a DCC command
station
You can program the configuration variables
(CVs) of the decoder from the command station.
Also take note of the relevant chapter of the man-
ual of your command station where the byte-wise
programming of (CVs) is explained.
Programming with Motorola central
units
Put the locomotive onto a track section connected
to the central unit's track output.
Make sure no other vehicle is located on the track
as the decoder in that vehicle will also be pro-
grammed.
Fig. 4
11

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

5241

Inhaltsverzeichnis