Specifications; Rotary Hammer Safety Warnings - Makita HR2230 Betriebsanleitung

ENGLISH
1. Switch trigger
2. Lock button
3. Reversing switch lever
4. Action mode changing knob
5. Grip base
6. Side grip
7. Loosen

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
ROTARY HAMMER SAFETY
WARNINGS
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. If you use this tool
unsafely or incorrectly, you can suffer serious
personal injury.
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
4
Explanation of general view
8. Tighten
9. Teeth
10. Protrusion
11. Bit shank
12. Bit grease
13. Bit
14. Chuck cover
Model
Concrete
Core bit
Diamond core bit (dry type)
Steel
Wood
-1
)
Blows per minute
Overall length
Net weight
Safety class
make exposed metal parts of the power tool "live" and
ENE042-1
could give the operator an electric shock.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
ENF002-1
thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
GEB007-6
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high
locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not point the tool at any one in the area when
operating. The bit could fly out and injure
someone seriously.
13. Do not touch the bit or parts close to the bit
immediately after operation; they may be
extremely hot and could burn your skin.
15. Depth gauge
16. Dust cup
17. Blow-out bulb
18. Chuck adapter
19. Keyless drill chuck
20. Sleeve
21. Ring
HR2230
22 mm
54 mm
65 mm
13 mm
32 mm
0 -1,050
0 - 4,050
357 mm
2.6 kg
/II