Specifications - Makita HM1801 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch lever
2-1. Indicator lamp
3-1. Bit with collar
3-2. Bit without collar
4-1. Bit
4-2. Tool retainer
4-3. Tool holder
4-4. When the bit is inserted
4-5. When the bit is retained

SPECIFICATIONS

Model
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for heavy chiselling and demolition
work as well as for driving and compacting with
appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.31 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
All manuals and user guides at all-guides.com
Explanation of general view
5-1. Notched portion
5-2. Tool retainer shaft
5-3. Barrel
5-4. When the bit is inserted
5-5. When the bit is retained
6-1. Commutator
6-2. Insulating tip
6-3. Carbon brush
7-1. Hex wrench 5
ENE046-1
For Model HM1801
Noise
The typical A-weighted noise level determined according
to EN60745:
ENF002-1
Vibration
The
determined according to EN60745:
ENF100-1
For Model HM1810
Noise
The typical A-weighted noise level determined according
to EN60745:
Vibration
The
determined according to EN60745:
3
7-2. Motor housing cover
8-1. Cap rubber
9-1. Brush holder cap
9-2. Screwdriver
10-1. Cap
10-2. Lock nut wrench 20
11-1. Cap
11-2. Hex wrench 8
12-1. Hammer grease
HM1801
1,100
824 mm
29.7 kg
/II
Sound pressure level (L ) : 84 dB(A)
pA
Sound power level (L ) : 104 dB(A)
WA
Uncertainty (K) : 2.30 dB(A)
Wear ear protection
vibration total value (tri-axial
Work mode : chiseling function
Vibration emission (a ) : 14.0 m/s
h,CHeq
2
Uncertainty (K) : 1.5 m/s
Sound pressure level (L ) : 84 dB(A)
pA
Sound power level (L ) : 104 dB(A)
WA
Uncertainty (K) : 2.52 dB(A)
Wear ear protection
vibration total value (tri-axial
Work mode : chiseling function
Vibration emission (a ) : 9 m/s
h,CHeq
2
Uncertainty (K) : 1.5 m/s
HM1810
1,100
824 mm
32.3 kg
ENG102-3
ENG215-2
vector sum)
2
ENG102-3
ENG215-2
vector sum)
2