Specifications; Intended Use - Makita DHR182 Betriebsanleitung

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Capacities
No load speed
Blows per minute
Overall length
Rated voltage
Net weight
Optional accessory
Model:
Suction performance
Operating stroke
Suitable drill bit
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge
BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 / BL1840B / BL1850 / BL1850B / BL1860B
• Some of the battery cartridges listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges listed above. Use of any other battery cartridges may cause
injury and/or fire.

Intended use

The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745-2-6:
Model DHR182
Sound pressure level (L
Sound power level (L ) : 100 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Model DHR182 with DX05
Sound pressure level (L
Sound power level (L ) : 101 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Concrete
Core bit
Diamond core bit (dry type)
Steel
Wood
) : 89 dB(A)
pA
) : 90 dB(A)
pA
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
WARNING:
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
11 ENGLISH
DHR182
18 mm
35 mm
32 mm
13 mm
24 mm
-1
0 - 1,350 min
-1
0 - 5,000 min
301 mm
D.C. 18 V
2.4 - 3.2 kg
DX05
250 l/min
Up to 90 mm
Up to 160 mm
0.9 kg
Wear ear protection.
The noise emission during actual
Be sure to identify safety mea-