Adjusting The Telescopic Guide Rail; Checking The Battery Charge Level; Charging The Battery; Operation - Parkside Pfba 20-Li C3 Originalbetriebsanleitung

GB MT
Removing the brush (Fig. C)
1. Push the brush support (22) to-
wards the motor head (8).
2. Pull the brush (13, 14) out of the
brush support.
3. Release the brush support.
Adjusting the telescopic
guide rail
Procedure
The telescopic guide rail (6) enables
you to adjust the device to your indi-
vidual height.
1. Loosen the coupling nut (5).
2. Adjust the telescopic guide rail (6)
to the desired length.
3. Retighten the coupling nut.
Checking the battery
charge level
LEDs
red, orange, green Battery charged
red, orange
red
1. Press the button (18) next to the
charge level indicator button (17)
on the battery (16).
The LEDs of the charge level in-
dicator show how much charge re-
mains in the battery.
2. Charge the battery (16) when only
the red LED on the charge level in-
dicator (17) is illuminated.

Charging the battery

See also the charger instruction
manual.
Notes
• If warm, allow the battery to cool
before charging.
• Do not expose the battery to dir-
ect sunlight for long periods and
30
Meaning
Battery partially
charged
Battery needs to
be charged
do not place it on a radiator (max.
50°C).
Charging the battery
1. Remove the battery (16) from the
device.
2. Push the battery (16) into the char-
ging slot of the battery charger
(19).
3. Connect the battery charger (19) to
a power outlet.
4. After charging, disconnect the bat-
tery charger (19) from the mains.
5. Pull the battery (16) out of the bat-
tery charger (19).
Control LEDs on the charger (19):
green red
lights up —
— lights up Battery is char-
— flashes
flashes flashes

Operation

Working instructions

WARNING! Risk of injury! Pay at-
tention to the following instructions.
CAUTION! When working with wire
and nylon brushes, never move the
brush across plastic or other delicate
flooring material. The brushes could
scratch or damage the surface. We
do not assume any liability for dam-
ages in this case. Test the brush be-
forehand on an inconspicuous area.
• Check the attachment tool before
use. Never use damaged attach-
Meaning
• Battery is fully
charged
• stand-by (No
battery inser-
ted)
ging
Battery is over-
heated
Battery is defect-
ive