Lorelli ki-Rider Bedienungsanleitung Seite 6

Step 5. Grasp the seat body to check the seat if it is fastened tightly or shakes
(Picture 8). If the seat shakes and the FIX connectors are pulled out, please
repeat the above steps and install it again. To release the seat , push backwards
the release buttons "2" from both sides and pull out the seat.
Step 6. Position the shoulder
its neck) and over the armrest of the safety seat. Thread the abdominal
under the armrest of the seat and over the lap of the child, then fasten the belt in
the buckle of the car until you hear "click" (Picture 11, 12). Check that the belt
buckle is locked by pulling the belt (Picture 7, 8, 9;10).
Step 7. Make sure the belt is properly positioned
and does not interfere
Please use the car's 3-point seat belts to ensure the safety of the child and
secure the car seat.
Step 1. The car seat should only be used as a seat.
seat ovthe vehicle in the forward-facing
Step 2. Put the child in the car seat and make sure the belt is not twisted or tied.
Step 3. Position the shoulder belt over the child's shoulder (but away from the
child's neck) and over the armrest of the safety seat. Route the lap belt under
the seat armrests and over the child's lap, then fasten the belt into the vehicle
buckle until it clicks (Figure 11; 13).
Check that the belt buckle is secure by pulling on the belt.
Step 4. Ensure that the seat belt is correctly placed through all the guides, is not
twisted and does not bother the child ( Figure 8; 9; I O).
Route of the adult safety beltforward-facing,
150 cm. Route the seat belt as shown in (Figure 11; 12) and fasten until you
hear a "click". Pull on the seat
is not twisted.
WASHING INSTRUCTIONS
1. The car seat can be cleaned
aggressive cleaning agents such as abrasives or solvents.
2. The cover must be hand washed at a maximum temperature
put it in the dryer. Allow the cover to air-dry.
3. Plastic parts can be cleaned with a damp cloth. Do not use abrasives.
Removing the cover: Remove the cover as shown in Figure. 14
belt over the shoulder
with the child.
INSTALLATION OF SEAT
Routing the adult safety belt
belt to make
with lukewarm
of the child (but away from
across all guides, not twisted
With 3 - Point
Place the car seat on the
position.
installation
sure the buckle
water and soap. Do not use
Belt
for height 125-
is secure and the belt
of 300C. Do not
belt