Werbung
1. INSTALLING THE CAR SEAT
TO INSTALL THE CAR SEAT, FOLLOW THE STEPS BELOW:
EN
1a- Unfold the support leg (15) to its upright position.
1b- Lift the button (11) to extend the ISOFIX arms (9) backwards. Perform this step on both arms.
1c- Guide the ISOfix arms towards the anchorage points in your vehicle. Press until they lock into
place. You will hear a click and the indicators on the connector will change from red to green. Check
both sides of the base.
1d- Press the Car Seat against the vehicle seat back. Then, pull the Car Seat forward to check that it
is securely fastened.
1e- Press the button (14) to adjust the height of the support leg (15) until it contacts the vehicle floor.
The leg must NOT rest on the lid of any type of compartment. Ensure that the support leg is at a 90
degree angle to the Car Seat.
TO REMOVE THE SEAT, FOLLOW THE SAME STEPS IN REVERSE:
1f- Pull the button (12) to open the connector and release it from the anchorage point.
18
Werbung
