Herunterladen Inhalt Inhalt Diese Seite drucken

VEVOR R7313 Bedienungsanleitung Seite 7

Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 33
electric shock, fire and/or serious injury.
b) This power tool is not recommended for grinding,wire brushing or cutting
off operations.Operations for which the power tool was not designed may
create a hazard and cause personal injury.
c) Do not allow any loose portion of the bonnet or its attachment strings to
spin freely. Tuck away or trim any loose attachment strings. Loose and
spinning attachment strings can entangle your fingers or snag on the work
piece.
d) Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can
be attached to your power tool, it does not assure safe operation.
e) The rated speed of the accessory must be at least equal to the
maximum speed marked on the power tool.Accessories running faster than
their rated speed can fly apart.
f) The outside diameter and the thickness of your accessory must be within
the capacity rating of your power tool. Incorrectly sized accessories cannot
be adequately guarded or controlled.
g) The arbour size of wheels, flanges, backing pads or any other accessory
must properly fit the spindle of the power tool.Accessories with arbour
holes that do not match the mounting hardware of the power tool will run
out of balance, vibrate excessively and may cause loss of control.
h) Do not use a damaged accessory. Before each use inspect the
accessory such as abrasive wheels for chips and cracks, backing pads for
cracks, tear or excess wear, wire brushes for loose or cracked wires. If the
power tool or accessory is dropped, inspect for damage or install an
undamaged accessory.After inspecting and installing an accessory,
position yourself and bystanders away from the plane of the rotating
accessory and run the power tool at maximum no load speed for one
minute. Damaged accessories will normally break apart during this test
time.
i ) Wear personal protective equipment .Depending on application, use
face shield,
safety goggles or safety glasses.As appropriate, wear dust mask, hearing
protectors, gloves and shop apron capable of stopping small abrasive or
- 6 -
Inhaltsverzeichnis
loading

Inhaltsverzeichnis