VEVOR R7313 Bedienungsanleitung Seite 13

REPLACING THE BACKING PAD
● Flip the sander over and place on a flat, level surface.
● Use the S6 wrench to unscrew the screw in the center of the disk
counterclockwise.
● Remove the old pad and change to the new one.
● Tighten the screw clockwise.
VACUUM PIPE INSTALLATION
● Choose one end of the vacuum pipe, connected to the dust outlet of the
machine.
● Choose another end of the vacuum pipe, connect with 35mm adapter
first, then connected with the vacuum cleaner.
OPERATING INSTRUCTIONS
The tool is intended to be operated as a hand held tool. The tool can be
used in any position. Note! The sander can develop a torque reaction when
started. Make sure the sander is switched off. Select a suitable abrasive
and secure it to the backing pad. Make sure the abrasive is centered on the
backing pad. Switch on the sander by pressing the On/Off key, The sander
LED is now green.
1. The sander can now be started by pressing the lever.
2. The speed can be adjusted between 4,000rpm and max rpm by
adjusting the position of the lever.
- 12 -