After Use - Vevor R7313 Bedienungsanleitung

wear a dust mask and work with a dust extraction device when
connectable
● Follow the dust-related national requirements for the materials you want
to work with.
● Secure the work-piece (a work-piece clamped with clamping devices or
in a vice is held more securely than by hand).
● Do not clamp the tool in a vice.
● Use completely unrolled and safe extension cords with a capacity of 10
Amps.

AFTER USE

● Before you put down the tool, switch off the motor and ensure that all
moving parts have come to a complete standstill
● After switching off the tool, never stop the rotation of the accessory by a
lateral force applied against it.
Proper use of tool
This sander is designed for sanding all types of materials, i.e.metals, wood,
stone, plastics,etc.using abrasives designed for this purpose. Do not use
this sander for any other purpose than that specified without consulting the
manufacturer or the manufacturer's authorized supplier
Work stations
The tool is intended to be operated as a hand-held tool.It is always
recommended that the tool should be used when standing on a solid floor.It
can be in any position but before any such use,the operator must be in a
secure position,having a firm grip and footing and be aware that the sander
can develop a torque reaction.See the section "Operating instructions".
ATTACHING AND CHANGING THE SANDING PAPER
Place the sanding paper in the center of the sanding pad and press on.
The holes in the sanding paper must be in alignment with the holes in the
sanding pad. For round sanding pad only: conduct a test run to check that
the sanding disc is clamped in the center.
- 11 -