Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Function test
• Your device will automatically ap-
pear in the Homematic IP App.
• Enter the last four digits of the de-
vice number (SGTIN) in your app,
or scan the QR code. The device
number can be found on the stick-
er supplied or attached to the de-
vice.
• Wait until pairing is completed.
• If pairing was successful, the LED
lights up green. The device is now
ready for use. If the LED lights up
red, please try again
codes and flashing sequences" on
page
30).
• Allocate the device to a room.
• Assign a name for the device.
• Allocate the device to a solution.
After switching on the power
supply, the device requires ap-
prox. 30 seconds until it is ready
for operation. No motion will be
detected during this time.
After pairing has been completed,
the function test of the motion
detector starts
test" on page
(see „9 Error
(see „8 Function
29).
8 Function test
The function test is only activated
if the motion detector has already
been added.
Up to 10 minutes after pairing or after
switching on the power supply (if the
device has already been paired), the
main lens signals detected movements
in the colour corresponding to the de-
tection zone.
The lens flashes in colour each time a
movement is detected. This allows the
detection range and sensitivity to be
checked directly at the sensor
Error codes and flashing sequences" on
page
30).
(see „9
29
Werbung
