Programming Mode - Sick Pac50 Betriebsanleitung

Operating Instructions
SP1/FH1 (Settings for switching point 1/upper window limit 1)
•
RP1/FL1 (Settings for reset point 1/lower window limit 1)
•
SP2/FH2 (Settings for switching point 2/upper window limit 2)
•
RP2/FL2 (Settings for reset point 2/lower window limit 2)
•
Analog output (electrical output signal in mA or V)
•
LOW (minimum applied pressure value that has been stored since the last reset)
•
HIGH (maximum applied pressure value that has been stored since the last reset)
•
Return to display mode by pressing the buttons
.

7.4 Programming mode

7.4.1 Setting the device parameters
To switch to programming mode, the
programming mode is inactive for a long period (> 15 seconds), the device automatically reverts back to
display mode. The measuring and switching functions continue to run (in the background) while the device is
in programming mode.
Selecting:
•
display area B: e.g. "SET" is helpful in this regard.
To select the parameter/menu item to be set, press the
•
Making settings:
The parameter value to be set is displayed in display area A. Display areas C1/2 and E1/2 display the
•
existing parameter value settings.
The parameter is set using the
•
•
pushbutton, even if the pressure switch is still in programming mode.
8017612/ZAB1/2017-02-14 | PAC50
Subject to change without notice
7 Operation and parameter settings
and simultaneously or by pressing the middle button
pushbutton must be pressed for longer than 2 seconds. If the
and
and pushbuttons. The note in
pushbutton in the middle.
O p e r a t i n g I n s t r u c t i o n s | S I C K
PAC50
pushbutton.
6 7