What To Do If - IKEA LAGAN Bedienungsanleitung

ENGLISH
5. Loosen the
drainage chan-
nel from its rest-
ing position at
the bottom of
the appliance,
push it in ac-
cording to the
illustration and
put a bowl un-
der the outlet where you can collect the
water.
6. Carefully scrape off the ice when it starts to
thaw. Use the provided plastic scraper.
7. When all the ice has melted, clean and
wipe the cabinet dry, then put the drainage
channel back in place.
8. Switch on the appliance.
9. Reload the previously removed food into
the compartments.
Important! Let the appliance run on the
highest settings for some hours so that it can
reach the sufficient storing temperature as
soon as possible.

What to do if...

Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent per-
son must do the troubleshooting that is not in
this manual.
Problem
The appliance is noisy.
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
Possible cause
The appliance is not supported
properly.
The appliance is switched off.
The plug is not connected to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
Warning! Never use sharp metal tools to
scrape off frost from the evaporator as
you could damage it. Do not use a mechanical
device or any artificial means to speed up the
thawing process other than those
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long pe-
riods, take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost, if foreseen
4. Clean the appliance and all accessories.
5. Leave all doors ajar to prevent unpleasant
smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food in-
side from spoiling in case of a power failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Solution
Check if the appliance stands
stable (all the feet should be on
the floor).
Switch on the appliance.
Connect the plug to the mains
socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Refer to "Replacing the lamp".
11