Ryobi RMS-1825 Bedienungsanleitung Seite 27

Fig. 26:
A. Fence
B. Filler block, face pointing upwards
C. Moulding
D. Table
When the filler blocks are attached to the fence face down, the moulding must be placed on the table right side up. This is
the same position as the moulding will have when nailed between the ceiling and wall. Make 2 filler blocks 25 mm long.
Fasten the blocks securely to the fence. For the block face to point downward, you may need to drill new fastener holes in
the fence.
Fig. 27:
A. Filler block, face pointing downwards
B. Moulding
C. Table
28. VERTICAL BEVEL CUTTING (Fig. 28)
To make a mitre cut in a workpiece in the vertical position (on edge), a spacer, such as the previously described auxiliary
fence, is required. The fence is located in the front position.
Fig. 28:
A. Space block
B. Fence
C. Workpiece
29. ANGLE SETTING FOR COMPOUND CUTS (Fig. 29)
A compound cut is a cut requiring both a mitre setting and bevel setting. This type of cut is used for making frames or boxes
that have sloping sides and are wide at one end and narrow at the opposite end. Compound cuts are "tricky" to make because
the mitre setting and bevel setting are directly related to each other. Every time the mitre setting is changed the bevel setting
must also be adjusted, and vice versa. Because it may take several tries to obtain the desired angle, it is advisable to make
test cuts on a scrap piece of wood.
30. MOTOR TROUBLE-SHOOTING
PROBLEM ENCOUNTERED
Motor does not start
Angle of cut not accurate
Cannot move position of mitre
scale indicator
Powerhead wobbles
Powerhead does not fully rise
Blade binds, jams, burns wood
Tool vibrates or shakes
DIAGNOSIS
1. Fuse problem
2. Brushes worn
3. Other
1. Misalignment
1. Sawdust under the table
1. Loose pivot points
1. Pivot misadjustment
2. Damaged part
3. Pivot spring not inserted properly
after service
1. Improper operation
2. Dull saw blade
or inappropriate blade
1. Saw blade not round
2. Saw blade damaged
3. Saw blade loose
4. Other
27
REMEDY
- Change the fuse
- Change the brushes
- Contact Authorised Service Centre
- See Saw Mounting section
- Vacuum or blow out dust
WEAR EYE PROTECTION
- See Saw Mounting section
- See Saw Mounting section
- Contact Authorised Service Centre
- Contact Authorised Service Centre
- Replace or sharpen saw
- Replace blade with one designed
for the material to be cut
- Replace saw blade
- Replace saw blade
- Tighten arbor screw
- Contact Authorised Service Centre
GB