Ryobi RMS-1825 Bedienungsanleitung Seite 22

GB
N. Base
O. Fence
P. Blade-changing spanner
Q. Sawdust extraction outlet
R. Upper blade guard
S. Lock button
9. UNPACKING AND CHECKING CONTENTS (Fig. 4)
The Mitre Saw is shipped complete in one box. Unpack all parts and check each item using the illustration and "Table of
Unmounted Parts". Make sure all items are accounted for before discarding any packing material.
WARNING
If any parts are missing, do not try to assemble the mitre saw, plug in the power cable or switch on the machine until
the missing parts have been obtained and installed correctly.
ITEM
A
B
C
D
E
F
G
H
I
J
10. SAW MOUNTING
WARNING
To avoid accidents, please read the following instructions carefully:
1. Before moving the saw, lock the mitre, bevel and powerhead positions. Unplug electric cable.
2. To avoid back injury, get help when you need to lift the saw more than 30 cm. Hold the saw close to your body. Bend your
knees so you can lift with your legs, not your back. Lift by using the hand-hold areas at the bottom of the base.
3. Never carry the mitre saw by the power cable. Carrying the saw by the power cable could cause damage to the insulation
or the wire connections resulting in electric shock or fire.
4. Position the saw so other people cannot stand behind it. Thrown debris could injure people in its path.
5. Place the saw on a firm, level surface where there is plenty of room for handling and properly supporting the workpiece.
6. Support the saw so the table is level and the saw does not rock.
7. Secure the saw in the desired location on a work bench. Place the saw in the desired location on a work bench. The base
of the saw has four holes for mounting purposes. If the saw is to be used in one location, fasten it to the work bench.
11. MOUNTING THE LOWER BLADE GUARD (Fig. 5 - 6 - 7)
WARNING
To avoid accidents caused by unintentional starting or electrical shock, do not plug the saw in until all assembly and
alignment steps are complete. The power cable must remain unplugged whenever you are working on the saw.
NOTE: For compact shipment, the lower blade guard has been removed.
1. The mitre saw is equipped with a handle latch, used to lock the mitre saw in the lowered position. To change the position
of the saw, push the handle down slightly and pull the handle latch upwards.
2. Release the handle latch and raise the saw to its upper position.
3. Loosen screw 1 and remove screw 2.
4. Remove screw 3 and spacer from lower guard.
5. Slide slotted end of lower guard mounting bracket under screw head and rotate lower guard mounting bracket until hole
in bracket lines up with threaded hole in upper guard.
TABLE OF UNMOUNTED PARTS
Saw
Lower blade guard
Instruction manual
Dust bag
Clamp assembly
Side extension arm
U-bracket
Stop block thumb screw
Stop fence plate
Thumb screw
QTY.
1
1
1
1
1
2
2
1
1
1
22