Cleaning And Maintenance; Replacing The Fuse - EuroLite 51930440 Bedienungsanleitung

Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Key
Blackout LEDs off
SPR Internal programs; via „+/-„ the 11 internal programs can be chosen
FL Flash on or off; via „+/-„ the speed can be regulated
SP Speed; via „+/-„the color change and color fade speed can be regulated
D DMX mode
SA Sound control mode; via „+/-„ the sensitivity can be regulated
SL Master/Slave mode
S Setting DMX address; via 0, 1, 2, 3, 4, 5, 6, 7, 8, 9 the DMX addresses can be
set
R (red)
G (green)
Static colors; via „+/-„ the brightness can be regulated
B (blue)
W (UV)

CLEANING AND MAINTENANCE

Disconnect from mains before starting maintenance operation!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse-holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse-holder.
Step 3: Install the new fuse in the fuse-holder.
Step 4: Replace the fuse-holder in the housing.
CAUTION!
not be disposed of with regular domestic waste!
Parameter
DANGER TO LIFE!
27/28 00098844, Version 1.1