Connection Between Devices; Connection With The Mains; Operation; Stand-Alone Mode - EuroLite 51930440 Bedienungsanleitung

Connection between devices

On the rear panel, there is an IEC socket (Power Out). Connect the output with the input of the next fixture
until all fixtures are connected.
Attention: It is recommended to renew the connection with the power mains after every 8 devices.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the device to the mains, the EUROLITE LED BAR-1250 RGB+UV 4in1 starts running.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board and via
the EUROLITE IR-8 remote control or in DMX-controlled mode via any commercial DMX controller.

STAND-ALONE MODE

In the stand-alone mode, the device can be used without controller.
Disconnect the device from the controller. Please refer to the instructions under chapter Control Board.

Control Board

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
program or select a DMX channel mode.
MODE UP DOWN ENTER
The display shuts off after 30 seconds of inactivity. With the touch of a button it lights up again.
International
L
N
Browse through the main menu by pressing MODE. You can browse through
the submenu and confirm your choice by pressing ENTER. You can change
the selection by pressing UP or DOWN. You can leave every mode by pressing
MODE.
The functions provided are described in the following sections.
23/28 00098844, Version 1.1