Midea MDRB489FGE Bedienungsanleitung Seite 25

Problem
Door seal fails to be
tight
Water pan overflows
EN EN
Hot housing
Surface
condensation
Abnormal noise
• Remove foreign matters on the door seal
• Heat the door seal and then cool it for restoration (or blow it
with an electrical drier or use a hot towel for heating)
• There is too much food in the chamber or food stored contains
too much water, resulting in heavy defrosting
• The doors are not closed properly, resulting in frosting due to
entry of air and increased water due to defrosting
• Heat dissipation of the built-in condenser via the housing, which
is normal When housing becomes hot due to high ambient
temperature, storage of too much food or shutdown of the
compressor is shut down, provide sound ventilation to facilitate
heat dissipation
• Condensation on the exterior surface and door seals of the
refrigerator is normal when the ambient humidity is too high.
Just wipe the condensate with a clean towel.
• Buzz: The compressor may produce buzzes during operation,
and the buzzes are loud particularly upon start or stop. This is
normal.
• Creak: Refrigerant flowing inside of the appliance may produce
creak, which is normal.
Possible reason
20