Scheppach S800 Originalbetriebsanleitung Seite 19

Store the product in its original packaging. Cover the
product to protect it from dust or moisture. Store the
operating manual with the product.
• Empty the collection bucket and clean the product
before putting it into storage.
• To save space, the push bar can be folded. In this
case, loosen the screws of the lower and upper push
bar, pull the push bar upwards and fold it forwards.
(Fig. 9)
13. Maintenance
The product has no internal parts that require mainte-
nance.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
15. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Debris remains.
Brushes do not rotate.
Reduced sweeping width.
Possible cause
Sweeping brush worn out.
Collection bucket defective.
Belts worn out.
Belts torn.
Quick release fastener not
locked.
Brushes worn out.
www.scheppach.com
Wearing parts*: Belts, brushes, sweeping brushes
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
14. Disposal and recycling
Notes for packaging
The packaging materials are recycla-
ble. Please dispose of packaging in
an environmentally friendly manner.
Remedy
Replace sweeping brush.
Replace collection bucket.
Replace belts. Contact the service department.
Replace belts. Contact the service department.
Check quick release fastener.
Replace brushes.
GB | 19